Perth Street Bikes

Go Back   Perth Street Bikes

View Single Post
Old 07-02-2007, 09:28 PM   #19 (permalink)
goofy
996, Daytona 675, RM250, CR125
 
goofy's Avatar
 
Funnily enough, I've always used the hair dryer for the really hard to get off stickers. Tea tree oil to get the residue off

Quote:
there was some sort of sticker remover that had an orange sort of smell to it a while ago... I used it to get rid of some off my bike...
(very old container though, not sure if they still have it around)...works a treat though.[/b]
Mirks, where the hell do you come up with these extremely fucking helpful suggestions? Do you even think before you type?
__________________
The 996 mods: Stealth look Termis, JhP High flow air filters, Eprom chip, DP Monoposto, LED tail, DP Light weight Flywheel, Hardened Chrome Rockers, DP Sprocket cover, DP Carbon Exhaust guard, Tinted screen, Front Number Board, DP Ergal Fuel filler, STM Superbike quick chance sprocket carrier, STM Oil Breather, STM clutch cylinder, DP fender eliminator, DP Carbon Hugger, Carbon Heel Guards, Warpspeed Rad Guard, Carbon Air Tube Covers, Carbon Key Guard, Carbon Instrument Cover, Titax Levers.
goofy is online now   Reply With Quote
 
» Sponsors
Powered by vBadvanced CMPS v3.0 RC2


All times are GMT +8. The time now is 02:03 PM.

Powered by vBulletin® Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.

Advertise on PSB

Copyright 2008 © PerthStreetBikes.com Pty Limited (ACN 127 435 858)

By using this website, you are indicating your acceptance of the TERMS OF USE