Can't remove bar ends on new CBR250

[Gray_]

Any ideas here? I read they used "locktite" or something on the screws. I can't get them to budge for love or money.
Tried WD40 and boiling water too.
I want to replace them with me new "go faster" red ones

[Goldmember]

you should be able to remove them just try abit harder than normal and they should come free

[kapyong]

WD40 will help and plenty of elbow grease

[I Fancy Holidays]

Impact driver or if they are similar to the GPX bar end you can drill it out. Removing & replacing bar ends - Ninja250Wiki

[michael]

I dont know what type or "fastener" is used to hold them in the bar, but if its a tapered type like barkbusters, unscrew it a few turns then bump the screw/bolt into the bar with a hammer should release the clamp.

Michael.

[Goldmember]

Try the impact driver that should remove it