CBR 250R Tail Lights out

[lobes89]

Hi guys.
got the bike back together running and all, except for the tail lights are not working...

i have opened the switch block on it cleaned the contacts out,
tested from the fuse box through to the wiring and the circuit is complete, ie sending signal....
the brake lights work fine as the front lights/ highbeam/ indicators and all..
all fuses are ok... and working fine

from my stroke of somewhat genius i have found that the circuit is complete, the only problem im thinking is from the ignition to the switch block?

one idea given to me from ma pa was take it to an auto sparkie and get them to wire from ignition to lights so they are always on.. (the park lights). thinking last resort... however couldn't harm if that was the case.. bypassing fuses, and switch blocks...

ANy ideas would be handy......

by the by the bike is a 250 cbr 1989 mc19....

[lobes89]

any help at all??

[courtz]

That sounds odd =/ unfortunately I know little about electrics to be able to offer any help (other than a free bump to your thread!).

Change your avatar to one of a hot chick - I'm sure advice will come flooding your way

[Goldmember]

Did you happen to disconnect any wires? If so it might be worth while to check the brake light assembly.
Have you looked at the bulbs by any chance at they could have blown.

PM me if you need a hand.

[lobes89]

courtz wanna send me one?? it's ok I spent three hours on Thursday night looking and after following my dads advice I decided to double check the bulbs to find out they were gone but learnt all bout the bikes electrics and riding again just need to put the indicators back on ( fronts)