powervalve assembly problem

[BrendonM]

ok so got everything in, then go to put shaft in and the last spacer wont go on straight the bolt underneath is holding it there on an angle.

any special way to do this?


p.s yes i have used the correct bolts.

[chee]

its pretty straight forward.

are you talking about the grub screw? and the lifter arm thing?

[WIGARUS]

i'm confused which bit you're talking about?

[rgvlee]

as above, i have no idea what you're referring to.

[BrendonM]

i figured out what i was refering to before, i now have a new problem which that diagram doesnt explain

-i dont know what position/where to rotate the pully?

-i dont know what postion that the spring mechanism behind to pully should be or what it does?

-and the top bolt behind the pully im not sure what it does or whats meant to be there?


this all realates to the bottom/right hand cylinder.

thanks

[WIGARUS]

okaaay, your talking about number 30 i'm assuming? that screw holds a washer over number 29. so that number 29 can't pop out and then swivel, because that would stop the pulley (number 34) from being held in to the right spot with the spring (number 32). See?

Simple.

[BrendonM]

ok so that answers my last question, but im still confused about the spring and where i should located the pully "stopper thing" on the back of the pully?

thanks again

[WIGARUS]

The pulley and number 29 both stick in between the spring ends, on the bottom cylinder, they point towards the rear of the bike and the top cylinder they point down.

[BrendonM]

so ive got to get the pully "stopper thing" inbetween the springs aswell as number 29?

[WIGARUS]

yes

[BrendonM]

ive got it now cheers for all the help everyone.

[chee]

i had issues with that. just played around with it for 10 minutes till i figured out how it should have worked.

[druu]

With the spring attached to the shaft already, all you really need to do is line up the hole on the shaft so the grub screw can screw in, simple.