View Full Version : Looking for a Mazda3 oil filter removal tool to buy/borrow (75.6mm 14 flute)

14-01-2013, 12:34 PM
Yea.. I know I could probably get away with a universal tool...

Anyone know where I can source the correct tool to remove the oil filter for a 1st Gen Mazda 3.

Correct Mazda size is 75.6mm 14 flute

Mazda dealer I called doesn't stock tools and Covs/Repco/Supercheap were not much help.


14-01-2013, 12:39 PM
I've got a complete oil filter wrench set (multiple sizes) your more than welcome to come and borrow. Its the same as this...

Rytool 14 piece filter wrench set (http://www.autopartswholesalers.com.au/brands/rytool/rytool-14-piece-filter-wrench-set?catid=16734)

14-01-2013, 01:49 PM
Got a few here, I'm in Wilson if you're close by, welcome to borrow them. Just shoot me a pm

14-01-2013, 02:17 PM
Also have one if you need to borrow one in the midland area

15-01-2013, 04:41 PM
Thanks guys, Tim is just around the corner so probably the easiest (will be in touch).

Rennis / TenKate are either of yours 75.6mm ? Tim's set has a 76mm which will apparently work but if not and one of you have the exact size then I may need to borrow.

15-01-2013, 04:50 PM
Mine goes as small as 50mm up to 120mm81698

15-01-2013, 04:53 PM
More than welcome to borrow it if the other doesn't work m8

15-01-2013, 06:04 PM
Very similar to the one in the rennis' photo, the other is adjustable. Has been
dropping the oil for the sp23 using them so I think it's the rite size for your maz3

20-01-2013, 06:28 AM
Are you still chasing this tool or have you got it sussed out ? A big pair of multigrips will work too as they are never too tight because they have an O-ringon them. I have a hoist and large pair you can use. :cool:

20-01-2013, 07:31 AM
If your going to be change the oil filter yourself all the time. Do your self a favour, go to the wreckers, find one of the 2.0L models. Make sure it has the normal "spin on filter"... Unbolt the oil filter arm - then bolt to your engine.